Im out of ideas other than maybe although i thought i needed the VAG-K+CAN cable for my cable maybe i needed the older KKL 409. engine, instrument etc etc it always comes up with "interface not found" When i try and connect to all the different interfaces i.e. Clicked on options, port3 and interface was found no problem with a good latency of between 1 and 2ms. Fired up XP, installed drivers and 409.1. Researching, i have seen a post from someone else saying same problem and they were recommended to try VAGCOM 409.1 in windows XP which they said worked great. I have tried VCDS Lite and in options chose port3 and interface is found but I then click on the different interfaces to connect to and none of them will connect, says "interface no found". All drivers in ok and interface found and i can get the system to run the car identification so seems all working fine but i just cant do anything with it, it doesnt read anything else from the drop down menu, ive tried them all. It came with vag commander 1.4 chinese edition. Where to find VagCom software to my USB Cable KKL VAG-COM 409.1. Je pln funkn se vemi typy propojovacch kabel HEX-COM, HEX-CAN, HEX-V2 a HEX-NET, nemuste mt obavy z jejich znien. Ive done a bit of research and purchased a VAG-K+CAN full commander cable which i believed the right cable for my car. Zde si mete zdarma sthnout nejnovj verzi VCDS 23.3 k Vaemu kabelu HEX-CAN, HEX-COM, HEX-V2 nebo HEX-NET jen obsahuje pro program VCDS licenci.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |